Connect Tool

From Scrap Mechanic Wiki
Jump to: navigation, search
Connect Tool
Toolframe1.png
Overview
CategoryTools

The Connect Tool is one of the Tools in Scrap Mechanic.

Overview[edit | edit source]

Used to connect interactive parts together.

Usage[edit | edit source]

When the Connect Tool is selected, colored dots will appear on interactive parts. To connect one part to another, click and drag on one of the dots and release when hovering over another dot. If done successfully, a line should appear between the two parts, showing that they're connected. The line will also have small black arrows on it, indicating which part activates the other. The arrows point from the control part to the action part.

The numbering of parts connected to a Controller, Driver's Seat, or Seat and the rotation direction of Bearings connected to a Controller, Driver's Seat, Gas Engine, or Electric Engine are also visible when the Controller is selected. The rotation direction of connected bearings can be toggled with right-click.

To disconnect two connected parts, drag from one part to the other again, as if making another connection. Or, drag the connection off of the action part and release it when not hovering over any valid part. The latter method is much faster, because it requires less mouse movement.

Note that only parts belonging to the same construction may be connected. You can check this while dragging out a connection; all invalid connection points will disappear.

History[edit | edit source]

Alpha[edit | edit source]

  • ???
    • Added Connect Tool.