Mechanic's difficulty: Medium
- This is a guide on how to build a Buggy
Parts[ | ]
The Buggy will use the following Blocks and Parts:
- 35 Blocks of any kind
- 1 Drivers Seat
- 2 Controllers
- 1 Gas Engine
- 14 Bearings
- 4 Small Wheels
- 4 Sport Suspension
- 20 Pipe Corners
Building[ | ]
1. Make A 4x9 platform of your choice of block.
2. Place a Drivers Seat. Then place a Gas Engine behind it. Next place two controllers, one on each side of the engine.
3. Attach the pipe corners to the frame as shown.
4. Place 2 bearings on the front of the vehicle. This will be for the steering.
5. Place 4 pipe corners facing away from the center as shown.
6. Attach 4 bearings onto the faces of the pipe corners; Back and front.
7. Place 4 pipe corners on the bearings facing away from the vehicle.
8. Place 4 sport suspension on the pipes that you just placed.
9. Set the suspension tension to 6.
10. Place 4 pipe corners on the suspension as shown.
11. Attach 4 bearings to the pipes that you just placed.
12. Place the final corners (facing up) on the bearings.
13. Place 4 bearings (There are a lot of bearings) on the pipes that you just placed.
14. Finally, place the small wheels on the bearings.
Connections[ | ]
1.This part is tricky, so follow the steps carefully.
- Lets start with the left controller. (facing the back)
- Connect the front bearings to the controller on the left. (the vertical bearings)
- Do Not connect the wheel or steering bearings to the controllers! (the horizontal bearings)
2. Connect the back bearings the right controller. (the vertical bearings)
3. In the left controller, set all the bearing angles to 45 degrees.
4. In the right controller, set all the bearing angles to 45 degrees.
5. Your vehicle should look like this when taken off the lift. If it does not, right click on the bearings with your connection tool. This will rotate the bearing angles. If still your vehicle doesn't stand up go to point 6. (and then try change bearing angles)
6. Connect the steering to the drivers seat. (Green)
7. Connect the engine to the seat. (Green)
8. Connect the engine to the front bearings. (Orange)
9. Set the gas engine power to 4.
Uses[ | ]
- Each Controller requires 20 components to upgrade for usage in this build.
- Can be used for semi-rough terrain.
- Because of the symmetry of the build, the gas engine could be replaced with an electric engine. Electric engines have more torque, so you could hook a trailer to the buggy.